All TOYWATCH online watch purchases ship with a sizing tool (except watches in the Ceramic collection, which will need to be sized by a jeweler).
Before you start please note: Pins have a smooth side and a serrated side. Serrated side must be pushed out first when removing pin. Insert the smooth side first when replacing. Arrow direction on links points to direction in which pins should be pushed out.
1. Unscrew the handle of the sizing tool, counter-clockwise until it reaches the end of the tool.
2. Open the watch clasp.
3. Place watchband flat on top of the platform, with the smooth side of the pins facing the pin remover handle.
4. Line up the pin of the link that you would like to remove with the handle and the open slot on the tool.
5. Screw in the bit until the serrated side of the pin is pushed out.
6. Pull out the pin. (If pin is difficult to remove, use pliers to pull it out).
7. Count the links and repeat steps 1-3. If you are removing several links, we suggest removing them from both sides of the watchband ie. One link from one side and two from the other for a total of three links removed so that the watch is evenly sized.
8. Line up links and slide the pin in to the connected links with the smooth end first.
9. Push in the pin , against the arrow direction, with the flat side of the sizing tool until it is flush with the side of the link.
|
|
